H3C S6550X-HI Series Command Reference Manual page 1387

Predefined user roles
network-admin
Parameters
: Specifies the maximum number of ECMP routes. No ECMP load balancing is available
number
when the number is set to 1.
Usage guidelines
You can use the
by the system to m. After a reboot, the value range for the
load-balancing
Examples
# Set the maximum number of ECMP routes to 2.
<Sysname> system-view
[Sysname] ospf 100
[Sysname-ospf-100] maximum load-balancing 2
Related commands
max-ecmp-num
network
Use
network
Use
undo network
Syntax
network ip-address wildcard-mask
undo network ip-address wildcard-mask
Default
OSPF is not enabled for any interface.
Views
OSPF area view
Predefined user roles
network-admin
Parameters
ip-address
wildcard-mask
of mask 255.0.0.0 is 0.255.255.255.
Usage guidelines
This command enables OSPF on the interface attached to the specified network. The interface's
primary IP address must be in the specified network. If only the interface's secondary IP address is
on the network, the interface cannot run OSPF.
Examples
# Specify the interface whose primary IP address is on network 131.108.20.0/24 to run OSPF in Area
2.
<Sysname> system-view
command to set the maximum number of ECMP routes supported
max-ecmp-num
command is 1 to m.
to enable OSPF on the interface attached to the specified network in the area.
to disable OSPF for the interface attached to the specified network in the area.
: Specifies the IP address of a network.
: Specifies the wildcard mask of the IP address. For example, the wildcard mask
number
99
argument of the
maximum