H3C S6550X-HI Series Command Reference Manual page 2254

ipsec { ipv6-policy | policy } isakmp template
Use
ipsec { ipv6-policy | policy } isakmp template
policy entry by using an IPsec policy template.
Use
undo ipsec { ipv6-policy | policy }
Syntax
ipsec { ipv6-policy | policy } policy-name seq-number isakmp template
template-name
undo ipsec { ipv6-policy | policy } policy-name [ seq-number ]
Default
No IPsec policies exist.
Views
System view
Predefined user roles
network-admin
Parameters
ipv6-policy
: Specifies an IPv4 IPsec policy.
policy
policy-name
characters.
seq-number
smaller number indicates a higher priority.
isakmp template template-name
case-insensitive string of 1 to 63 characters.
Usage guidelines
If you specify the
entry. If you do not specify this argument, the
An interface applied with an IPsec policy that is configured by using an IPsec policy template cannot
initiate an SA negotiation, but it can respond to a negotiation request. The parameters not defined in
the template are determined by the initiator. When the remote end's information (such as the IP
address) is unknown, this method allows the remote end to initiate negotiations with the local end.
Examples
# Create an IPsec policy entry by using IPsec policy template temp1, and specify the IPsec policy
name as policy2 and the sequence number as 200.
<Sysname> system-view
[Sysname] ipsec policy policy2 200 isakmp template temp1
Related commands
display ipsec { ipv6-policy | policy }
ipsec { ipv6-policy-template | policy-template }
: Specifies an IPv6 IPsec policy.
: Specifies a name for the IPsec policy, a case-insensitive string of 1 to 63
: Specifies a sequence number for the IPsec policy, in the range of 1 to 65535. A
argument, the
seq-number
to delete an IPsec policy.
: Specifies an IPsec policy template by its name, a
command deletes the specified IPsec policy
undo
command deletes the specified IPsec policy.
undo
29
to create an IKE-based IPsec