H3C S6550X-HI Series Command Reference Manual page 1922

Usage guidelines
If you configure the RIPng packet sending rate for both a RIPng process and an interface running the
RIPng process, the configuration on the interface takes effect.
Examples
# Configure RIPng process 1 to send a maximum of 10 RIPng packets every 60 milliseconds.
<Sysname> system-view
[Sysname] ripng 1
[Sysname-ripng-1] output-delay 60 count 10
Related commands
ripng output-delay
preference
Use
preference
Use
undo preference
Syntax
preference { preference | route-policy route-policy-name } *
undo preference
Default
The preference of RIPng routes is 100.
Views
RIPng view
Predefined user roles
network-admin
Parameters
preference
value, the higher the preference.
route-policy route-policy-name
string of 1 to 63 characters.
Usage guidelines
You can specify a routing policy to set a preference for the matching RIPng routes.
•
The preference set by the routing policy applies to all matching RIPng routes. The preference of
other routes is set by the
•
If no preference is set by the routing policy, the preference of all RIPng routes is set by the
preference
Examples
# Set the preference for RIPng routes to 120.
<Sysname> system-view
[Sysname] ripng 100
[Sysname-ripng-100] preference 120
to set the preference for RIPng routes.
to restore the default.
: Specifies the preference for RIPng routes, in the range of 1 to 255. The smaller the
preference
command.
: Specifies a routing policy by its name, a case-sensitive
command.
16