H3C S6550X-HI Series Command Reference Manual page 2020

ospfv3 trans-delay
Use
ospfv3 trans-delay
Use
undo ospfv3 trans-delay
Syntax
ospfv3 trans-delay seconds [ instance instance-id ]
undo ospfv3 trans-delay [ instance instance-id ]
Default
The transmission delay is 1 second.
Views
Interface view
Predefined user roles
network-admin
Parameters
: Specifies the transmission delay in the range of 1 to 3600 seconds.
seconds
instance instance-id
Usage guidelines
Each LSA in the LSDB has an age that increases by 1 every second, but the age does not change
during transmission. Adding a transmission delay into the age time is important in low speed
networks.
Examples
# Set the transmission delay to 3 seconds for VLAN-interface 10 in instance 1.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 trans-delay 3 instance 1
pic
Use to enable PIC for OSPFv3.
pic
Use
undo pic
Syntax
pic [ additional-path-always ]
undo pic
Default
OSPFv3 PIC is enabled.
Views
OSPFv3 view
Predefined user roles
network-admin
to set the transmission delay for an interface.
to remove the configuration.
: Specifies an instance by its ID in the range of 0 to 255. The default is 0.
to disable PIC for OSPFv3.
86