H3C S6550X-HI Series Command Reference Manual page 1942

: Displays detailed OSPFv3 process information. If you do not specify this keyword, the
verbose
command displays brief OSPFv3 process information.
Examples
# Display detailed information about all OSPFv3 processes.
<Sysname> display ospfv3 verbose
RouterID: 1.1.1.1
IPv6 RouterID: 86::86
Route tag: 0
Route tag check: Disabled
Multi-VPN-Instance: Disabled
Type value of extended community attributes:
Domain ID : 0x0005
Route type: 0x0306
Router ID : 0x0107
Domain-id: 0.0.0.0
DN-bit check: Enabled
DN-bit set: Enabled
Isolation: Disabled
Originating router-LSAs with maximum metric
Condition: Always, State: Active
Advertise summary-LSAs with metric 16711680
Advertise external-LSAs with metric 16711680
Advertise intra-area-prefix-LSAs with maximum metric
ISPF: Enabled
SPF-schedule-interval: 5 50 200
LSA generation interval: 5
LSA arrival interval: 1000
Transmit pacing: Interval: 20 Count: 3
Default ASE parameters: Tag: 1
Route preference: 10
ASE route preference: 150
FRR backup mode: LFA
Node-Protecting Preference: 40
Lowest-cost Preference: 20
SPF calculation count: 0
External LSA count: 0
LSA originated count: 0
LSA received count: 0
SNMP trap rate limit interval: 10
Area count: 2
ExChange/Loading neighbors: 0
End.X SID deletion delay:
State
Delay time: 1800 sec
Max equal cost paths: 32
OSPFv3 Process 1 with Router ID 1.1.1.1
Router type:
Stub area count: 0
: Enabled
ABR ASBR NSSA
Count: 7
NSSA area count: 1
8