H3C S6550X-HI Series Command Reference Manual page 2008

Usage guidelines
Specify a router ID for the OSPFv3 process. Otherwise, the OSPFv3 process cannot generate LSAs.
Examples
# Enable OSPFv3 process 120 and set the router ID to 1.1.1.1.
<Sysname> system-view
[Sysname] ospfv3 120
[Sysname-ospfv3-120] router-id 1.1.1.1
ospfv3 area
Use
ospfv3 area
interface.
Use
undo ospfv3 area
Syntax
ospfv3 process-id area area-id [ instance instance-id ]
undo ospfv3 process-id area area-id [ instance instance-id ]
Default
No OSPFv3 processes are enabled on an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
process-id
: Specifies an area by its ID, an IPv4 address or a decimal integer in the range of 0 to
area-id
4294967295 that is translated into the IPv4 address format.
instance instance-id
Examples
# Configure VLAN-interface 10 to run instance 1 of OSPFv3 process 1 in Area 1.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 1 area 1 instance 1
ospfv3 authentication-mode
Use
ospfv3 authentication-mode
interface.
Use
undo ospfv3 authentication-mode
Syntax
ospfv3
instance-id ]
undo ospfv3 authentication-mode [ instance instance-id ]
to enable an OSPFv3 process on an interface and specify an area for the
to disable an OSPFv3 process on an interface.
: Specifies an OSPFv3 process by its ID in the range of 1 to 65535.
: Specifies an instance by its ID in the range of 0 to 255. The default is 0.
authentication-mode
to specify an authentication mode for an OSPFv3
to remove the configuration.
keychain keychain-name
74
[ instance