H3C S6550X-HI Series Command Reference Manual page 1977

Parameters
process-id
specify an OSPFv3 process, this command displays retransmission list information for all OSPFv3
processes.
area area-id
to 4294967295 that is translated into the IPv4 address format. If you do not specify an OSPFv3 area,
this command displays retransmission list information for all OSPFv3 areas.
interface-type interface-number
not specify an interface, this command displays retransmission list information for all interfaces.
neighbor-id
displays retransmission list information for all neighbors.
Examples
# Display OSPFv3 retransmission list information.
<Sysname> display ospfv3 retrans-queue
-------------------------------------------------------------------------
Type LinkState ID
0x2009 0.0.0.0
Table 24 Command output
Field
Area
Interface
Nbr-ID
Retransmit List
Type
LinkState ID
AdvRouter
SeqNum
Age
CkSum
display ospfv3 routing
Use
display ospfv3 routing
Syntax
display ospfv3 [ process-id ] routing [ ipv6-address prefix-length ]
: Specifies an OSPFv3 process by its ID in the range of 1 to 65535. If you do not
: Specifies an area by its ID, an IPv4 address or a decimal integer in the range of 0
: Specifies a neighbor's router ID. If you do not specify a neighbor, this command
OSPFv3 Process 1 with Router ID 1.1.1.1
Area: 0.0.0.0
Interface Vlan-interface100
Nbr-ID 1.2.2.2 Retransmit List
AdvRouter
1.3.3.3
: Specifies an interface by its type and number. If you do
SeqNum
0x80000001
Description
Area ID.
Interface type and sequence number.
Neighbor ID.
Retransmission list information.
LSA type.
Link state ID.
Advertising router.
LSA sequence number.
LSA age.
Checksum.
to display OSPFv3 route information.
43
Age CkSum
3600 0x49fb