H3C S6550X-HI Series Command Reference Manual page 2041

Table 2 Command output
Field
Global policy-based routing
information
node 0 deny
node 2 permit
if-match acl
apply next-hop
apply output-interface
Matches
bytes
Total matches
total bytes
Related commands
ipv6 global policy-based-route
display ipv6 policy-based-route interface
Use
display ipv6 policy-based-route interface
configuration and statistics.
Description
IPv6 global PBR configuration and statistics.
This field displays failed in brackets if none of the nodes in the policy
has been successfully issued to the driver. To successfully issue the
policy, you must remove the policy and then apply it again.
Match mode of the node, permit or deny.
If a node fails to be issued to the driver, the command displays the
cause in brackets, which include:
•
not support—The device does not support the match criteria
configured on the node.
•
no resource—No sufficient resources (for example, ACLs) are
available for the node.
Compares packets with the ACL.
Specifies a next hop for permitted packets.
Specifies an output interface for permitted packets.
This field displays the interface status in brackets.
•
down—The interface is down at the network layer.
•
inactive—The card that hosts the interface is not in position.
Number of successful matches on the node. If the device does not
have sufficient resources to count matches, this field displays no
statistics resource in brackets.
If the device does not support counting successful matches on a node,
this field displays N/A.
If match counting is disabled on the node, this field is not displayed.
Number of matching bytes on the node.
This field displays N/A if the device does not support counting
matching bytes on a node.
This field is not displayed if match counting is disabled on the node.
Total number of successful matches on all nodes.
This field displays N/A if the device does not support counting
successful matches on a node.
This field is not displayed if match counting is disabled on all nodes.
Total number of matching bytes on all nodes.
This field displays N/A if the device does not support counting
matching bytes on a node.
This field is not displayed if match counting is disabled on all nodes.
6
to display IPv6 interface PBR