H3C S6550X-HI Series Command Reference Manual page 2176

Parameters
remarking
interface-type interface-number
: Specifies the QoS policy applied to incoming traffic.
inbound
outbound
Usage guidelines
If you do not specify the
If you do not specify a direction, this command displays the QoS policy applied to incoming traffic
and the QoS policy applied to outgoing traffic.
Examples
# Display the generic QoS policy applied to the incoming traffic of Twenty-FiveGigE 1/0/1.
<Sysname> display qos policy interface twenty-fivegige 1/0/1 inbound
Interface: Twenty-FiveGigE1/0/1
Direction: Inbound
Policy: 1
Classifier: 1
Matched : 0 (Packets) 0 (Bytes)
5-minute statistics:
Forwarded: 0/0 (pps/bps)
Dropped
Operator: AND
Rule(s) :
If-match acl 2000
Behavior: 1
Marking:
Remark dscp 3
Committed Access Rate:
CIR 112 (kbps), CBS 51200 (Bytes), EBS 512 (Bytes)
Green action
Yellow action : pass
Red action
Green packets : 0 (Packets) 0 (Bytes)
Yellow packets: 0 (Packets) 0 (Bytes)
Red packets
Classifier: 2
Matched : 0 (Packets) 0 (Bytes)
5-minute statistics:
Forwarded: 0/0 (pps/bps)
Dropped
Operator: AND
Rule(s) :
If-match protocol ipv6
Behavior: 2
Accounting enable:
0 (Packets)
Filter enable: Permit
: Specifies marking-type QoS policies.
: Specifies the QoS policy applied to outgoing traffic.
remarking
: 0/0 (pps/bps)
: pass
: discard
: 0 (Packets) 0 (Bytes)
: 0/0 (pps/bps)
: Specifies an interface by its type and number.
keyword, this command displays generic QoS policies applied.
22