H3C S6550X-HI Series Command Reference Manual page 2130

# Display configuration and match statistics for IPv4 advanced ACL 3001.
<Sysname> display acl 3001
Advanced IPv4 ACL 3001, 2 rules
ACL's step is 5, start ID is 0
rule 0 permit tcp
rule 5 permit ip source 10.0.0.100 0 (2854 times matched)
Table 1 Command output
Field
Basic IPv4 ACL 2001 named
test
2 rules
match-order is auto
This is an IPv4 basic ACL.
ACL's step is 5
start ID is 0
rule 5 permit source 1.1.1.1 0
rule 5 comment This rule is
used on
Twenty-FiveGigE1/0/1.
Active
Inactive
2854 times matched
reset acl counter
Use
reset acl counter
Syntax
reset acl [ ipv6 | mac | user-defined ] counter { acl-number | all | name
acl-name }
Views
User view
Predefined user roles
network-admin
Parameters
: Specifies the IPv6 ACL type.
ipv6
: Specifies the Layer 2 ACL type.
mac
user-defined
acl-number
Description
Type, number, and name of the ACL.
The following field information is about IPv4 basic ACL 2001.
Number of rules contained in the ACL.
In this example, the ACL contains two rules.
The match order for the ACL is auto, which sorts ACL rules in depth-first
order. This field is not displayed when the match order is config.
Description of the ACL.
The rule numbering step is 5.
The start rule ID is 0.
Content of rule 5. The rule permits packets sourced from the IP address
1.1.1.1.
Comment of rule 5.
The rule that uses the time range is active.
The rule that uses the time range is inactive.
Number of times that the rule is matched.
to clear statistics for ACLs.
: Specifies the user-defined ACL type.
: Specifies an ACL by its number. The following are available value ranges:
6