H3C S6550X-HI Series Command Reference Manual page 1935

OSPFv3 commands
abr-summary
Use
abr-summary
Use
undo abr-summary
Syntax
abr-summary
cost-value ]
undo abr-summary ipv6-address prefix-length
Default
Route summarization is not configured on an ABR.
Views
OSPFv3 area view
Predefined user roles
network-admin
Parameters
ipv6-address
prefix-length
128. This argument specifies the number of consecutive 1s of the prefix, which defines the network
ID.
not-advertise
keyword, the command advertises the IPv6 summary route.
cost cost-value
default cost is the largest cost value among routes that are summarized.
Usage guidelines
This command applies only to an ABR to summarize multiple contiguous networks into one network.
To enable ABR to advertise specific routes that have been summarized, use the
abr-summary
Examples
# Summarize networks 2000:1:1:1::/64 and 2000:1:1:2::/64 in Area 1 into 2000:1:1::/48.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] area 1
[Sysname-ospfv3-1-area-0.0.0.1] abr-summary 2000:1:1:: 48
area
Use to create an OSPFv3 area and enter OSPFv3 area view.
area
Use
undo area
to configure route summarization on an ABR.
to remove the configuration.
ipv6-address
: Specifies the destination IPv6 address of the summary route.
: Specifies the prefix length of the destination IPv6 address, in the range of 0 to
: Specifies not to advertise the summary IPv6 route. If you do not specify this
: Specifies the cost of the summary route, in the range of 1 to 16777215. The
command.
to remove an OSPFv3 area.
prefix-length
1
[ not-advertise ] [ cost
undo