H3C S6550X-HI Series Command Reference Manual page 2028

Predefined user roles
network-admin
Parameters
interval trap-interval
60 seconds.
count trap-number
interval, in the range of 0 to 300. The value of 0 indicates that OSPFv3 does not output SNMP
notifications.
Examples
# Configure OSPFv3 to output a maximum of 10 SNMP notifications within 5 seconds.
<Sysname> system-view
[Sysname] ospfv3 100
[Sysname-ospfv3-100] snmp trap rate-limit interval 5 count 10
snmp-agent trap enable ospfv3
Use
snmp-agent trap enable ospfv3
Use
undo snmp-agent trap enable ospfv3
Syntax
snmp-agent
grhelper-status-change | if-state-change | if-cfg-error | if-bad-pkt |
neighbor-state-change | nssatranslator-status-change | virtif-bad-pkt |
virtif-cfg-error | virtif-state-change | virtgrhelper-status-change |
virtneighbor-state-change ] *
undo snmp-agent trap enable
grhelper-status-change | if-state-change | if-cfg-error | if-bad-pkt |
neighbor-state-change | nssatranslator-status-change | virtif-bad-pkt |
virtif-cfg-error | virtif-state-change | virtgrhelper-status-change |
virtneighbor-state-change] *
Default
SNMP notifications for OSPFv3 are enabled.
Views
System view
Predefined user roles
network-admin
Parameters
grrestarter-status-change
grhelper-status-change
if-state-change
if-cfg-error
if-bad-pkt
neighbor-state-change
: Specifies the SNMP notification output interval in the range of 2 to
: Specifies the number of SNMP notifications output by OSPFv3 at each
trap enable
: Specifies notifications about GR restarter state changes.
: Specifies notifications about GR helper state changes.
: Specifies notifications about interface state changes.
: Specifies notifications about error configuration of an interface.
: Specifies notifications about error messages received on an interface.
: Specifies notifications about neighbor state changes.
to enable SNMP notifications for OSPFv3.
to disable SNMP notifications for OSPFv3.
ospfv3 [ grrestarter-status-change
ospfv3 [ grrestarter-status-change
94
|
|