Hose Clamp Torque - PREVOST H3-41 Maintenance Manual

4.6 HOSE CLAMP TORQUE

E :
NGLISH
RECOMMENDED TIGHTENING
D
ESCRIPTION
C
ONSTANT
TORQUE
3/8 Hex
HOSE CLAMP (WAVE
E :
NGLISH
SEAL
D
ESCRIPTION
C
ONSTANT TORQUE
5/16 Hex
M :
ETRIC
7 mm Hex
HOSE CLAMP
( - )
LB IN
DRY
90-110
BREEZE)
AND
RECOMMENDED
( - )
TIGHTENING LB IN
DRY
55-65
HOSE CLAMP
(CAILLAU)
R
ECOMMENDED
T (L - )
IGHTENING B IN
DRY
30±2.2
PA1621 Maintenance Manual All Series | Section 00 revised Sept 2019
SECTION 00 : GENERAL INFORMATION
CAUTION
Cover electronic control components and wiring
to protect from hot sparks, etc.
CAUTION
Position welding machine ground clamp as
close as possible to the work. Ensure that the
welding machine ground return clamp is well
secured and makes a good electrical contact
with a large metallic area of the chassis located
as close as possible to the welding point.
CAUTION
Do not use TIG welding process on the vehicle.
This high frequency current process can
seriously damage the electronic components.
Refer to
Multiplex
Procedure Prior to Welding annexed at the end
of this section.
Modules Disconnection
17