19. Three-Phase Motor Control Timer Function; Introduction - Renesas M16C/64C User Manual

Table of Contents

Advertisement

M16C/64C Group

19. Three-Phase Motor Control Timer Function

19.1

Introduction

Timers A1, A2, A4, and B2 can be used to output three-phase motor drive waveforms.
Table 19.1 and Table 19.2 list Three-Phase Motor Control Timer Function Specifications. Three-Phase
Motor Control Timer Function Block Diagrams are shown in Figure 19.1 and Figure 19.2. Table 19.3 lists
I/O Ports.
Table 19.1
Three-Phase Motor Control Timer Function Specifications (1/2)
Item
Operation modes
Three-phase PWM
waveform output pins
Forced cutoff input
Used timers
Output waveform
Carrier wave cycle
R01UH0092EJ0110 Rev.1.10
Jul 31, 2012
Triangular wave modulation three-phase mode 0
Three-phase PWM waveform of triangular wave modulation is output.
Output data is updated every half cycle of the carrier wave, and an output
waveform is generated.
Triangular wave modulation three-phase mode 1
Three-phase PWM waveform of triangular wave modulation is output.
Output data is updated every cycle of the carrier wave, and an output
waveform is generated.
Sawtooth wave modulation mode
Three-phase PWM waveform of sawtooth wave modulation is output.
6 (U, U , V, V , W, W )
Input a low-level signal to the SD pin
Timers A4, A1, A2 (used in one-shot timer mode)
Timer A4: U-/ U -phase waveform control
Timer A1: V-/ V -phase waveform control
Timer A2: W-/ W -phase waveform control
Timer B2 (used in timer mode)
Carrier wave cycle control
Dead time timer (three 8-bit timers and shared reload register)
Dead time control
Triangular wave modulation, sawtooth wave modulation
All high or low outputs for one cycle supported
Output logic of high- and low-side turn-on signals can be set separately.
Triangular wave modulation :
Sawtooth wave modulation :
m: Setting value of the TB2 register, 0000h to FFFFh
fi: Count source frequency (f1TIMAB, f2TIMAB, f8TIMAB, f32TIMAB,
f64TIMAB, fOCO-S, fC32)
19. Three-Phase Motor Control Timer Function
Specification
(
) 2
×
m
+
1
---------------------------- -
fi
m
1
+
------------- -
fi
Page 328 of 807

Advertisement

Table of Contents
loading

This manual is also suitable for:

M16c/60 seriesM16c series

Table of Contents