Table of Contents
Advertisement
M16C/64C Group
Table 22.11
Registers and Setting Values in Pattern Match Mode (Independent Operation) (2/2)
Register
PMCiINT
PMC0CPC
PMC0CPD
PMCiHDPMIN
PMCiHDPMAX
PMCiD0PMIN
PMCiD0PMAX
PMCiD1PMIN
PMCiD1PMAX
PMCiTIM
PMC0DAT0 to
PMC0DAT5
PMC0RBIT
i = 0, 1
-: Unimplemented bits in PMC1
Note:
1.
This table does not describe a procedure.
R01UH0092EJ0110 Rev.1.10
Jul 31, 2012
Bit
Set to 1 when using compare
CPINT
match flag interrupt.
Set to 1 when using receive
REINT
error flag interrupt.
Set to 1 when using data
DRINT
reception complete interrupt.
Set to 1 when using receive
BFULINT
buffer full flag interrupt.
Set to 1 when using header
PTHDINT
match flag interrupt.
Set to 1 when using data 0/1
PTDINT
match flag interrupt.
TIMINT
Set to 0.
Set to 1 when using special
SDINT
data match flag interrupt.
CPN0
Select bits to be compared
CPN1
when using compare function.
CPN2
Set to 1 when using compare
CPEN
function.
Set compare value when using
0 to 7
compare function.
Set minimum value of header
0 to 10
pattern.
Set maximum value of header
0 to 10
pattern.
Set minimum value of data 0
0 to 7
pattern.
Set maximum value of data 0
0 to 7
pattern.
Set minimum value of data 1
0 to 7
pattern.
Set maximum value of data 1
0 to 7
pattern.
Measured value of pulse
0 to 15
period or width can be read.
0 to 7
Received data can be read.
Received bit count can be
0 to 5
read.
22. Remote Control Signal Receiver
Function
PMC0
Set to 1 when using receive
error flag interrupt.
Set to 1 when using data
reception complete interrupt.
Set to 1 when using header
match flag interrupt.
Set to 1 when using data 0/1
match flag interrupt.
Set to 0.
Set minimum value of header
pattern.
Set maximum value of header
pattern.
Set minimum value of data 0
pattern.
Set maximum value of data 0
pattern.
Set minimum value of data 1
pattern.
Set maximum value of data 1
pattern.
Measured value of pulse
period or width can be read.
(1)
PMC1
-
-
-
-
-
-
-
-
Page 429 of 807
Advertisement
Table of Contents
