Table of Contents
Advertisement
M16C/64C Group
Table 22.14
Registers and Setting Values in Pattern Match Mode (Combined Operation) (2/2)
Register
PMCiINT
PMC0CPC
PMC0CPD
PMCiHDPMIN
PMCiHDPMAX
PMCiD0PMIN
PMCiD0PMAX
PMCiD1PMIN
PMCiD1PMAX
PMCiTIM
PMC0DAT0 to
PMC0DAT5
PMC0RBIT
i = 0, 1
-: Unimplemented bit in PMC1
Note:
1.
This table does not describe a procedure.
R01UH0092EJ0110 Rev.1.10
Jul 31, 2012
Bit
Set to 1 when using compare
CPINT
match flag interrupt.
Set to 1 when using receive
REINT
error flag interrupt.
Set to 1 when using data
DRINT
reception complete interrupt.
Set to 1 when using receive
BFULINT
buffer full flag interrupt.
Set to 1 when using header
PTHDINT
match flag interrupt.
Set to 1 when using data 0/1
PTDINT
match flag interrupt.
TIMINT
Set to 0.
Set to 1 when using special
SDINT
data match flag interrupt.
CPN0
Select bits to be compared
CPN1
when using compare function.
CPN2
Set to 1 when using compare
CPEN
function.
Set compare value when using
0 to 7
compare function.
Set minimum value of header
0 to 10
pattern or special data pattern.
Set maximum value of header
0 to 10
pattern or special data pattern.
Set minimum value of data 0
0 to 7
pattern.
Set maximum value of data 0
0 to 7
pattern.
Set minimum value of data 1
0 to 7
pattern.
Set maximum value of data 1
0 to 7
pattern.
Measured value of pulse
0 to 15
period or width can be read.
0 to 7
Received data can be read.
Received bit count can be
0 to 5
read.
22. Remote Control Signal Receiver
Function
PMC0
Set to 0.
Set to 0.
Set to 0.
Set to 0.
Set to 0.
Set minimum value of header
pattern or special data pattern.
Set maximum value of header
pattern or special data pattern.
Set to 00h.
Set to 00h.
Set to 00h.
Set to 00h.
Not used.
(1)
PMC1
-
-
-
-
-
-
-
-
Page 435 of 807
Advertisement
Table of Contents
