Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 373

Table 7-150
INVALID SITE DATA FILE message
2 1 7
INVALID SITE DATA FILE
Display: Log message
2 1 8
Alarm Level:
No processor switch
2 1 9
Customer-Selected Alarm Level
2 2 0
Other Alarm Indications
2 2 1
System Recovery Action
2 2 2
Craftsperson Activity:
Table 7-151
IPCOM LOAD ERROR message
2 2 3 (log message)
IPCOM LOAD ERROR
Display: Log message
2 2 4
Alarm Level:
Processor switch inhibited
BMC II BISYNC Operation, Administration, and Maintenance Guide BMCB001 and up
Section 060-INDP-410 Command and Message Guide 4-213
Cause: output when the site data file read from disk is
rejected because it is the wrong size.
Reason Code = 14
Corresponds to ERRMAP entry: SITE FILE ERROR
System Default:
Type:MinorLevel:0
Type:Level:
Default:
Status Panel:MinorAudible:Minor
Customer-Selected
Status Panel:Audible:
None.
Refer to the Site File Error Procedure in the
Maintenance Procedures Guide section.
Cause: the booting of the standby processor failed
because a program block Inter-Processor
Communications (IPCOM) transfer failed and was
detected by the standby. (Message is from the standby
processor.)
Reason Code = N/A
Corresponds to ERRMAP entry: N/A
System Default:
Type:MajorLevel:3