Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 303

Table 7-77
DATA NOT AVAILABLE message
2 2
Other Alarm Indications
2 3
System Recovery Action
2 4
Craftsperson Activity:
Table 7-78
DEL. FAIL or DELETE FILE FAILED message
2 5
DEL. FAIL or DELETE FILE FAILED
Display: Log message
2 6
Alarm Level:
Based on the corresponding disk
error message
2 7
Customer-Selected Alarm Level
2 8
Other Alarm Indications
2 9
System Recovery Action
3 0
Craftsperson Activity:
BMC II BISYNC Operation, Administration, and Maintenance Guide BMCB001 and up
Section 060-INDP-410 Command and Message Guide 4-143
Default:
Status Panel: Audible:
Customer-Selected
Status Panel:Audible:
EOT message is sent to HOC.
Input the IDXMAINT SUMMARY AMA command.
Verify that the number of blocks to poll is greater than
the value assigned using VALPARM BLOCKS
command. If yes, verify the sequence number
requested by the HOC matches the BMC sequence
number to poll.
Cause: the attempt to delete a file failed due to a lack of
the file (file does not exist) or other problem.
Reason Code = N/A
Corresponds to ERRMAP entry: See Alarm Level
System Default:
Type: See Alarm Level
Type:Level:
Default:
Status Panel: See Alarm Level Audible:
Customer-Selected
Status Panel:
Based on corresponding disk error message.
Verify that the correct file name is being used. Refer to
the section on the DOS firmware command in this
document.
Level: N/A
Audible: