Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 404

4-244 Section 060-INDP-410 Command and Message Guide
Table 7-186
PURCHASED CAPACITY NOT AVAILABLE message
9 7 (log message)
PURCHASED CAPACITY NOT
AVAILABLE
Display: Log message
9 8
Alarm Level:
9 9
Customer-Selected Alarm Level
1 0 0
Other Alarm Indications
1 0 1
System Recovery Action
1 0 2
Craftsperson Activity:
Table 7-187
RAM TEST FAILED message
1 0 3
RAM TEST FAILED
Display: Log message
1 0 4
Alarm Level:
Processor switch
297-6201-502 Standard 01.02 September 2000
Cause: output when the amount of storage capacity (in
Logical Blocks) on the disk drive does not meet the
minimum requirements to support the software.
Reason Code = 0
Corresponds to ERRMAP entry: DISK ER MESSAGE
System Default:
Type:MinorLevel:0
Type:Level:
Default:
Status Panel:MinorAudible:Minor
Customer-Selected
Status Panel:Audible:
Disk remains off-line.
Refer to the Disk Drive Capacity Error Procedure in the
Maintenance Procedures Guide section.
Cause: output when a RAM data byte check fails.
Reason Code = N/A
Corresponds to ERRMAP entry: D_RAM ERROR
System Default:
Type:MajorLevel:1