Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 268

4-108 Section 060-INDP-410 Command and Message Guide
Table 4-40
Bx TEC DMA FAIL message
1 1 5 (log message)
B0 TEC DMA FAIL
(log message)
B2 TEC DMA FAIL
Display: Log message
1 1 6
Alarm Level:
Processor switch: if the message is
from the active TEC/DSI PCA
during normal operation = Major
Alarm, Level 1.
No switch: if the message is from
the standby TEC/DSI PCA during
normal operation = Minor Alarm,
Level 0.
None: if at power-up.
1 1 7
Customer-Selected Alarm Level
1 1 8
Other Alarm Indications
1 1 9
System Recovery Action
1 2 0
Craftsperson Activity:
297-6201-502 Standard 01.02 September 2000
Where: x = TEC/DSI Port ID
= 0 = TEC/DSI PCA in slot 13.
= 2 = TEC/DSI PCA in slot 12.
Cause: output when a DMA transfer of a data block has
not been initiated within 16 milliseconds of the
acknowledged request. Message is from the TEC/DSI
PCA.
Reason Code = 25
Corresponds to ERRMAP entry:
TEC STNBY FAIL Minor Alarm, Level 0 (or)
TEC PRIME FAIL Major Alarm, Level 1
System Default:
Type:See Alarm LevelLevel:N/A
Type:Level:
Default:
Status Panel: See Alarm Level Audible:
Customer-Selected
Status Panel: Audible:
a. Processor switch if the message is from the active
TEC/DSI PCA port.
b. No processor switch if the message is from the
standby TEC/DSI PCA port.
Refer to the TEC/DSI PCA Diagnostic Procedure in the
Maintenance Procedures Guide section.