Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 354

4-194 Section 060-INDP-410 Command and Message Guide
Table 7-126
FILE READ IN PROCESS message
7 6
Other Alarm Indications
7 7
System Recovery Action
7 8
Craftsperson Activity:
Table 7-127
FL EOB message
7 9 (log message)
FL EOB
(False End-of-Block)
Display: Log message
8 0
Alarm Level:
if active unit = processor switch
= Major alarm; Level 1
if standby unit = no processor
switch = Minor alarm; Level 0
8 1
Customer-Selected Alarm Level
8 2
Other Alarm Indications
297-6201-502 Standard 01.02 September 2000
Default:
Status Panel:Audible:
Customer-Selected
Status Panel:Audible:
Requested is aborted.
Attempt command when polling is complete.
Cause: output when a tape command line goes true,
when it was expected to go false. The command line is
not equal to 0.
This output should not appear during normal operation;
used by Nortel for test and verification purposes only.
Ignore this message if it appears when changing TEC/
DSI PCAs or removing TEC/DSI cables.
Reason Code = N/A
Corresponds to ERRMAP entry: N/A
System Default:
Type:See Alarm LevelLevel:N/A
Type:Level:
Default:
Status Panel:See Alarm Level Audible:
Customer-Selected
Status Panel: Audible: