Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 367

Table 7-142
INPUT BLOCK CHECKSUM ERROR message
1 6 9
INPUT BLOCK CHECKSUM
ERROR
Display: Log message
1 7 0
Alarm Level:
N/A
1 7 1
Customer-Selected Alarm Level
1 7 2
Other Alarm Indications
1 7 3
System Recovery Action
1 7 4
Craftsperson Activity:
Table 7-143
INVALID ADDR message
1 7 5 INVALID ADDR
Display: Maintenance terminal
1 7 6
Alarm Level:
N/A
1 7 7
Customer-Selected Alarm Level
BMC II BISYNC Operation, Administration, and Maintenance Guide BMCB001 and up
Section 060-INDP-410 Command and Message Guide 4-207
Cause: output when a call record block record block
received from the Switching System is in error.
Reason Code = N/A
Corresponds to ERRMAP entry: N/A
System Default:
Type:N/ALevel:N/A
Type:Level:
Default:
Status Panel:Audible:
Customer-Selected
Status Panel:Audible:
None
Refer to the TEC/DSI PCA Diagnostic Procedure in the
Maintenance Procedures Guide section.
Cause: a program load from disk failed because one of
the program records had a load address out of the
allowed loading range.
Reason Code = N/A
Corresponds to ERRMAP entry: N/A
System Default:
Type:N/ALevel:N/A
Type:Level: