Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 388

4-228 Section 060-INDP-410 Command and Message Guide
Table 7-167
NO DISK ON LINE message
3 1 9 (log message)
NO DISK ON LINE
Display: Log message
3 2 0
Alarm Level:
N/A
3 2 1
Customer-Selected Alarm Level
3 2 2
Other Alarm Indications
3 2 3
System Recovery Action
3 2 4
Craftsperson Activity:
Table 7-168
NO FILE AVAILABLE message
3 2 5 NO FILE AVAILABLE
Display: Maintenance terminal
3 2 6
Alarm Level:
N/A
3 2 7
Customer-Selected Alarm Level
297-6201-502 Standard 01.02 September 2000
Cause: output when a disk job attempts to select the
PRIME or STANDBY disk drive unit before either of the
disk drive unit(s) have been put on-line.
Reason Code = 27
Corresponds to ERRMAP entry: DSK MODE ALARM
System Default:
Type:MajorLevel:0
Type:Level:
Default:
Status Panel:MajorAudible:Major
Customer-Selected
Status Panel:Audible:
None.
Refer to the Disk Drive Diagnostic Procedure in the
Maintenance Procedures Guide section.
Cause: output when the requested file does not exist, is
not open, or does not have the necessary
characteristics for the designated operation.
Reason Code = N/A
Corresponds to ERRMAP entry: N/A
System Default:
Type:N/ALevel:N/A
Type:Level: