Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 430

4-270 Section 060-INDP-410 Command and Message Guide
Table 7-214
xxxxxx FILE yyyyyy ERROR: ee message
= 00 = indicates file is closed
= 02 = active file table full
= 04 = file not closed
= 06 = file expired
= 08 = Quad SIO error
= 10 = channel busy
= 12 = file not open for reading
= 14 = illegal file ID
= 16 = buffer overflow
= 18 = empty file is closed
2 6 6
Alarm Level:
See the procedure for the particular
message.
2 6 7
Customer-Selected Alarm Level
2 6 8
Other Alarm Indications
2 6 9
System Recovery Action
2 7 0
Craftsperson Activity:
297-6201-502 Standard 01.02 September 2000
= 01 = directory full
= 03 = no such file
= 05 = file not open
= 07 = error writing last block
= 09 = file write protected
= 11 = end of file
= 13 = hardware error
= 15 = illegal buffer ID
= 17 = no more room on disk
= 19 = illegal file name
Cause: an error occurred accessing the specified file
during the specified operation.
Reason Code = N/A
Corresponds to ERRMAP entry: See the procedure for
the particular message.
System Default:
Type:See Alarm LevelLevel:1
Type:Level:
Default:
Status Panel:See Alarm Level
Customer-Selected
Status Panel: Audible:
As specified for the associated error message.
If the SITDAT files are seen, refer to the Site File Error
Procedure in the Maintenance Procedures Guide
section. If BOOTCP files are seen, refer to the Boot
File Recovery Procedure in the same section. If
TDYSTS or YDYSTS files are seen, refer to the
Statistical File Error Procedure in the same section. For
any other files, contact the next level of support.
Audible:Major