Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 470

Billing media converter ii

Hide thumbs Also See for DMS-10 Series:

Table of Contents

6-32 Section 060-INDP-610 Maintenance Procedures Guide

Data Deﬁnitions

5 characters after AA

Boot Recovery Procedure

This procedure assumes the user has been referred here by a failure message.

There are a number of different alarms that could refer the user to this

procedure. This procedure should only be started when user has veriﬁed the

alarm is on the standby processor using the ERRMAP ALARMS command.

297-6201-502 Standard 01.02 September 2000

4 bytes before AA are Record Descriptor Word (RDW) for following call

Start of new call record

Structure code for call, refer to the Commands and Messages Guide

section for breakdown of fields and definitions

Field separator within call record

Last two bytes of block (includes C) is CRC for parity

As at end of block are fill characters from Switching System

Show Quick Links

Chapters

Table of Contents

Dms-100 series