Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 116

2-88 Section 060-INDP-111 System Description
The following table describes the fields for the DISK report.
Table 2-20
Disk report field descriptions
Field
VENDOR ID
PRODUCT ID
REVISION LEVEL
DISK CAPACITY
USER CAPACITY
MANUFACTURE
DEFECTS
GROWN DEFECTS
SCSI BUS
ERRORS
DISK ERRORS
PEAK LOAD
297-6201-502 Standard 01.02 September 2000
Note 9: If this report is requested while the disk system is in AO or BO,
the report column for off-line disk contains the characters N/A for
VENDOR ID, PRODUCT ID, REVISION LEVEL, DISK CAPACITY,
USER CAPACITY, MANUFACTURE DEFECTS, and GROWN
DEFECTS. SCSI BUS ERRORS, DISK ERRORS, and PEAK LOAD are
still reported. PEAK LOAD reports as 0.
Note 10: If the disk mode is NONE, N/A appears in both columns for
VENDOR ID, PRODUCT ID, REVISION LEVEL, DISK CAPACITY,
USER CAPACITY, MANUFACTURE DEFECTS, and GROWN
DEFECTS. SCSI BUS ERRORS, DISK ERRORS, and PEAK LOAD are
still reported. PEAK LOAD reports as 0.
Description
Identifies the manufacturer of the disk drive
Identifies the disk drive. Up to 16 digits (two fields)
Indicates the revision level of disk controller firmware
Size of the disk drive in logical blocks
Available disk space in logical blocks
Number of disk defects mapped out by the manufacturer
Number of defects found and mapped out during system operation
Number of recoverable failed attempts to communicate with the indicated disk
drive via the SCSI bus.
Number of errors reported by the disk drive
Highest number of disk jobs processed during a specified time period (i.e.,
per 24 hour interval)