Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 355

Table 7-127
FL EOB message
8 3
System Recovery Action
8 4
Craftsperson Activity:
Table 7-128
FORMAT FAILED message
8 5
FORMAT FAILED
Display: Maintenance terminal
Note: The DISK FORMAT x command is used in extreme emergencies ONLY and then under the
direction of the Nortel Technical Support personnel.
8 6
Alarm Level:
N/A
8 7
Customer-Selected Alarm Level
8 8
Other Alarm Indications
8 9
System Recovery Action
9 0
Craftsperson Activity:
BMC II BISYNC Operation, Administration, and Maintenance Guide BMCB001 and up
Section 060-INDP-410 Command and Message Guide 4-195
a. If the message is from the active unit (Major Alarm,
Level 1), a processor switch occurs.
b. If the message is from the standby unit (Minor
Alarm, Level 0), no processor switch occurs.
Verify cable placement and status of MTU ports on the
Switching System. In addition, refer to the TEC/DSI
PCA Diagnostic Procedure in the Maintenance
Procedures Guide section.
Cause: output on termination due to failure of the format
operation as a result of the DISK FORMAT A (or B)
command.
Reason Code = N/A
Corresponds to ERRMAP entry: N/A
System Default:
Type:N/ALevel:N/A
Type:Level:
Default:
Status Panel:Audible:
Customer-Selected
Status Panel:Audible:
None (disk task is terminated)
Refer to the Disk Drive Replacement Procedure in the
Maintenance Procedures Guide section.