Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 265

Table 4-36
BX.25 INTER-TASK COMM ERROR message
9 5
System Recovery Action
9 6
Craftsperson Activity:
Table 4-37
Bx TEC BUSY message
9 7
B0 TEC BUSY
B2 TEC BUSY
Display: Maintenance terminal
9 8
Alarm Level:
N/A
9 9
Customer-Selected Alarm Level
1 0 0
Other Alarm Indications
1 0 1
System Recovery Action
1 0 2
Craftsperson Activity:
BMC II BISYNC Operation, Administration, and Maintenance Guide BMCB001 and up
Section 060-INDP-410 Command and Message Guide 4-105
Polling ceases.
If this message is persistent, refer to the 56K Interface
PCA Replacement Procedure in the Maintenance
Procedures Guide section.
Where: x = TEC/DSI Port ID
= 0 = TEC/DSI PCA in slot 13.
= 2 = TEC/DSI PCA in slot 12.
Cause: output during TEST command execution if the
standby TEC/DSI PCA is busy.
Reason Code = N/A
Corresponds to ERRMAP entry: N/A
System Default:
Type:N/ALevel:N/A
Type:Level:
Default:
Status Panel: Audible:
Customer-Selected
Status Panel:Audible:
None
Verify test at another time.