Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 488

6-50 Section 060-INDP-610 Maintenance Procedures Guide
Procedure 6-13
Disk Drive Full
Step Description
146
Compare the printout in step 10 with a full directory listing to verify whether there are any
files that need to be deleted. Enter the following (at the terminal):
>LSTDIR ALL(cr)
System responds with a directory listing of all files on this disk, by file name and version
number.
If there are AMACRD files that appear in this listing, but, did not appear in the IDXMAINT
DIR CLOSED AMA listing from step 5, they should be deleted using step 12 below. If
there are multiple listings of any other files, they should be deleted to bring the disk usage
to a manageable limit. Proceed to step 12 for this procedure.
147
Enter the following command to delete unnecessary data using information provided by
data center before procedure was started. If ALL data is needed, DO NOT DELETE ANY
FILES.
>DELFILE xxxxxx vv ee (cr)
where:
xxxxxx- file name
vv- starting version number
ee- ending version number.
297-6201-502 Standard 01.02 September 2000
Sheet 5 of 5