Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 236

4-76 Section 060-INDP-410 Command and Message Guide
B0 TEC TEST PASSED
B2 TEC TEST PASSED
DMA TEST PASSED
RAM TEST PASSED
ROM TEST PASSED
PRG TEST PASSED
To request that the series of tests be run on the standby processor, issue the
following command:
>DOS S TEST (cr)
The system displays the test results for the standby processor. The display is
the same as for active processor.
VALPARM LOGHDR
The VALPARM LOGHDR command displays or changes the value of the log
header display.
Examples of command usage
To display the current status of the log header display, use the following
command:
>VALPARM LOGHDR (cr)
The system responds with a message showing the current status of the log
header display.
LOGGING OF AMA HEADERS ENABLED
or
LOGGING OF AMA HEADERS DISABLED
To change the status of the log header display, use the following command:
>VALPARM LOGHDR xxx (cr)
where:
xxx -status of log header display.
297-6201-502 Standard 01.02 September 2000
Note 18: These tests run independently. The test completion order
shown above is only an example. The order in which the tests complete
can vary.
Note 19: The DSK test is not run on the standby processor.
Note 20: Complete group of tests requires about three minutes to
perform.
(ON option)
(OFF option)