Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 357

Table 7-130
FORMAT NOT ALLOWED message
9 7
FORMAT NOT ALLOWED
Display: Maintenance terminal
Note: Use the DISK FORMAT x command only in extreme emergencies and then only under the
direction of Nortel field support.
9 8
Alarm Level:
N/A
9 9
Customer-Selected Alarm Level
1 0 0
Other Alarm Indications
1 0 1
System Recovery Action
1 0 2
Craftsperson Activity:
BMC II BISYNC Operation, Administration, and Maintenance Guide BMCB001 and up
Section 060-INDP-410 Command and Message Guide 4-197
Cause: printed in response to the DISK FORMAT
command when both drives are on-line. Also output in
response to DISK FORMAT when the BMC is in ONLY
mode and the disk selected for formatting is the active
disk.
Reason Code = N/A
Corresponds to ERRMAP entry: N/A
System Default:
Type:N/ALevel:N/A
Type:Level:
Default:
Status Panel:Audible:
Customer-Selected
Status Panel:Audible:
Termination of disk job.
Check to determine which disk drive is to be formatted
and input the correct disk drive. Refer to the Disk Drive
Diagnostic Procedure in the Maintenance Procedures
Guide section if the problem continues.