Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 338

4-178 Section 060-INDP-410 Command and Message Guide
Table 7-107
DISK: RST-7 message
2 0 1
Customer-Selected Alarm Level
2 0 2
Other Alarm Indications
2 0 3
System Recovery Action
2 0 4
Craftsperson Activity:
Table 7-108
DISK: x FAILURE message
2 0 5
DISK: x FAILURE
Display: Log message
2 0 6
Alarm Level:
Major
2 0 7
Customer-Selected Alarm Level
297-6201-502 Standard 01.02 September 2000
Type:Level:
Default:
Status Panel:MinorAudible:Minor
Customer-Selected
Status Panel:Audible:
Disk system restarts task.
If this message is seen more than once, replace the
SCSI Interface PCA using the Miscellaneous PCA
Replacement Procedure in the Maintenance
Procedures Guide section.
Where: x = specific device (that failed)
= PROCESSOR
= EPROM
= PRAM1
= SRAM
= STACK
= PC RANGE
= SRAM2
Cause: SCSI Interface PCA has failed a major
diagnostic routine.
Reason Code = N/A
Corresponds to ERRMAP entry: DSK CARD HW ERR
System Default:
Type:MajorLevel:2
Type:Level: