Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 332

4-172 Section 060-INDP-410 Command and Message Guide
Table 7-99
DISK: COMMAND ERROR message
1 5 2
Alarm Level:
Possible disk mode change
1 5 3
Customer-Selected Alarm Level
1 5 4
Other Alarm Indications
1 5 5
System Recovery Action
1 5 6
Craftsperson Activity:
Table 7-100
DISK: DMA INTERRUPT message
1 5 7 (log message)
DISK: DMA
INTERRUPT DMA REGISTERS:
xx(1) xx(2) xx(3)
xx(4) xx(5) xx(6)
xx(7)
Display: Log message
1 5 8
Alarm Level:
No change in disk mode
1 5 9
Customer-Selected Alarm Level
297-6201-502 Standard 01.02 September 2000
Reason Code = 27
Corresponds to ERRMAP entry: DISK ER MESSAGE
System Default:
Type:MinorLevel:0
Type:Level:
Default:
Status Panel:MinorAudible:Minor
Customer-Selected
Status Panel:Audible:
Varies, depending upon the specific error type.
If the disk system is made non-redundant, refer to the
Disk Drive Replacement Procedure in the Maintenance
Procedures Guide section.
Where: xx = DMA register data
Cause: SCSI Interface DMA controller generates an
interrupt.
Reason Code = 27
Corresponds to ERRMAP entry: DISK ER MESSAGE
System Default:
Type:MinorLevel:0
Type:Level: