Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 596

6-158 Section 060-INDP-610 Maintenance Procedures Guide
Table 6-17
Error Control II Jumper PCA options - part number: NTM609AB
Device type
(number)
Jumper
Strap
DIP Switch
Rotary Switch
Switch On =
toggle
(SW1)
Off =
Note 13: There are no customer-definable options on this PCA. Information is shown for reference
only. Use this data for verification during initial BMC system installation and/or PCA replacement to
make sure the replacement PCA is set up the same as the PCA being replaced.
Note 14: The LED (DS1) lights when toggle switch (SW1) is moved to the (up) On position.
297-6201-502 Standard 01.02 September 2000
Position/setting
None Used
None Used
None Used
None Used
up position = power cut to
Error Control II PCA in A5
is off.
down position = power
feed to Error Control II
PCA in A5 is on.
Function
Error control
functions transferred
to this circuit pack.
Error control
functions operate
normally.
Setting
Factory On-site
Used only during
corrective maintenance
on the Error Control II
PCA (A5).