Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 279

Table 4-51
CP COMMAND NOT ACCEPTED message
1 8 1 (log message)
CP COMMAND NOT ACCEPTED
Display: Log message
1 8 2
Alarm Level:
N/A
1 8 3
Customer-Selected Alarm Level
1 8 4
Other Alarm Indications
1 8 5
System Recovery Action
1 8 6
Craftsperson Activity:
BMC II BISYNC Operation, Administration, and Maintenance Guide BMCB001 and up
Section 060-INDP-410 Command and Message Guide 4-119
Cause: output when the CP will not accept site data
written to or read from the disk such as on the hour. It
is output as a response to any CP command that is not
accepted.
Reason Code = N/A
Corresponds to ERRMAP entry: N/A
System Default:
Type:N/ALevel:N/A
Type:Level:
Default:
Status Panel: N/AAudible: N/A
Customer-Selected
Status Panel:Audible:
None.
If a SITDAT WRITE or SITDAT READ command was
issued, try again. If this message persists, switch
processors. If that does not resolve the problem,
contact your next level of support.