Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 334

4-174 Section 060-INDP-410 Command and Message Guide
Table 7-102
DISK: MULTIPLE REASSIGN CONDITION message
1 6 9
DISK: MULTIPLE REASSIGN
CONDITION
Display: Maintenance terminal
1 7 0
Alarm Level:
N/A
1 7 1
Customer-Selected Alarm Level
1 7 2
Other Alarm Indications
1 7 3
System Recovery Action
1 7 4
Craftsperson Activity:
297-6201-502 Standard 01.02 September 2000
Cause: this message follows a DISK: COMMAND
ERROR message. An additional bad sector has been
located on the disk. Relocation cannot be scheduled;
data in that sector is lost.
Reason Code = N/A
Corresponds to ERRMAP entry: DSK CARD HW ERR
System Default:
Type:MajorLevel:2
Type:Level:
Default:
Status Panel:MajorAudible:Major
Customer-Selected
Status Panel:Audible:
Disk system is placed in or remains in an ONLY mode.
Refer to the Disk Drive Diagnostic Procedure in the
Maintenance Procedures Guide section.