Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 308

4-148 Section 060-INDP-410 Command and Message Guide
Table 7-82
DISK DIRECTORY FULL message
4 9 (log message)
DISK DIRECTORY FULL
Display: Log message
5 0
Alarm Level:
5 1
Customer-Selected Alarm Level
5 2
Other Alarm Indications
5 3
System Recovery Action
5 4
Craftsperson Activity:
297-6201-502 Standard 01.02 September 2000
Cause: output when the disk directory meets the
following conditions:
a. maximum number of files that can exist is exceeded.
When an attempt is made to create an AMA index file
fails because the disk directory is full, an attempt is
made to delete the oldest secondary file. When the file
is deleted, the log messages related to the deletion of
secondary AMA files are output (no alarm is
generated).
b. If this same failure occurs when there are no
secondary AMA files to delete, an attempt is made to
delete LOG files (no alarm is generated).
c. If this error occurs and there are no secondary AMA
or LOG files to delete, an EOT message is output to
both ports and a DIRECTORY FULL alarm is
generated.
Reason Code = 08
Corresponds to ERRMAP entry: DIRECTORY FULL
System Default:
Type:CriticalLevel:0
Type:Level:
Default:
Status Panel:CriticalAudible:Critical
Customer-Selected
Status Panel:Audible:
EOT is generated to both MTU ports in the Switching
System (BMC is not receiving AMA data).
Refer to the Disk Drive Diagnostic Procedure in the
Maintenance Procedures Guide section.