Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 264

4-104 Section 060-INDP-410 Command and Message Guide
Table 4-35
BOTH DISKS FULL message
8 7
Customer-Selected Alarm Level
8 8
Other Alarm Indications
8 9
System Recovery Action
9 0
Craftsperson Activity:
Table 4-36
BX.25 INTER-TASK COMM ERROR message
9 1 (log message)
BX.25 INTER-TASK COMM ERROR
Display: Log message
9 2
Alarm Level:
N/A
9 3
Customer-Selected Alarm Level
9 4
Other Alarm Indications
297-6201-502 Standard 01.02 September 2000
Type:Level:
Default:
Status Panel:CriticalAudible:Critical
Customer-Selected
Status Panel:Audible:
System has already set disk status nonredundant.
Refer to the Disk Drive Diagnostic Procedure in the
Maintenance Procedures Guide section to alleviate this
condition. (Call for technical assistance if doubt arises
at any step.)
Cause: polling task on the MP cannot communicate
with the CP. Generally, any error producing this
message will also be caught by the RFT task or MP/CP
audit task.
Reason Code = N/A
Corresponds to ERRMAP entry: N/A
System Default:
Type:N/ALevel:N/A
Type:Level:
Default:
Status Panel: Audible:
Customer-Selected
Status Panel:Audible: