Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 339

Table 7-108
DISK: x FAILURE message
2 0 8
Other Alarm Indications
2 0 9
System Recovery Action
2 1 0
Craftsperson Activity:
Table 7-109
DMA BUSY message
2 1 1
DMA BUSY
Display: Maintenance terminal
2 1 2
Alarm Level:
N/A
2 1 3
Customer-Selected Alarm Level
2 1 4
Other Alarm Indications
2 1 5
System Recovery Action
2 1 6
Craftsperson Activity:
BMC II BISYNC Operation, Administration, and Maintenance Guide BMCB001 and up
Section 060-INDP-410 Command and Message Guide 4-179
Default:
Status Panel:MajorAudible:Major
Customer-Selected
Status Panel:Audible:
Processor Switch
If this message is seen more than once, replace the
SCSI Interface PCA using the Miscellaneous PCA
Replacement Procedure in the Maintenance
Procedures Guide section.
Cause: output when a DMA function is requested while
the DMA is busy (while TEST command is running).
Reason Code = N/A
Corresponds to ERRMAP entry: N/A
System Default:
Type:N/ALevel:N/A
Type:Level:
Default:
Status Panel:Audible:
Customer-Selected
Status Panel:Audible:
None
If this message is seen during periods of low traffic,
replace the CPU PCA using the Miscellaneous PCA
Replacement Procedure in the Maintenance
Procedures Guide section.