Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 546

6-108 Section 060-INDP-610 Maintenance Procedures Guide
Procedure 6-32
Statistical File Error
Step Description
12
The STAT FILE ERROR error map alarm message can occur if the statistics files are
damaged or multiple files are present on the disk. Enter the following commands to
determine the number of each type of statistics files on the disk.
>LSTDIR FILE TDYSTS 1 255 (cr)
and
>LSTDIR FILE YDYSTS 1 255 (cr)
System response: xx nnnnnn xx yy xx xx xx xx xx xx xx xx xx
where:
nnnnnn- file name
yy- file version number (value of xx is not important to this procedure).
There will be one response line for each file found on the disk. Normally there is only one
version of each TDYSTS and YDYSTS file on the disk. If more than one TDYSTS file is on
disk go to step 4. If more than one YDYSTS file is on disk go to step 5. If one each of the
TDYSTS and/or YDYSTS files are on disk go to step 6.
13
Determine which open file is the TDYSTS file then close the TDYSTS file. Enter the
following command to list the active files:
>LSTACT (cr)
System responds with four open files listed with the format of FILE OPEN nn xx xx yyyy,
where nn is the file identification number and yyyy is 256 (number of bytes representing
the TDYSTS file). Value of xx is not important to this procedure. Enter the following
command to verify that the file identification number matches the TDYSTS file:
>LSTDIR FILE nn (cr)
System response: xx TDYSTS xx vv xx xx xx xx xx
where: vv - file version number (value of xx is not important to this procedure).
Enter the following command to close the open TDYSTS file:
>CLSACT nn (cr)
System response: FILE CLOSED
297-6201-502 Standard 01.02 September 2000
(Sheet 2 of 3)
xx xx xx xx