Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 346

4-186 Section 060-INDP-410 Command and Message Guide
Table 7-116
EC-CF-ALM message
1 3 (log message)
EC-CF-ALM
(Error Control-Conflict-Alarm)
Display: Log message
1 4
Alarm Level:
No processor switch
1 5
Customer-Selected Alarm Level
1 6
Other Alarm Indications
1 7
System Recovery Action
1 8
Craftsperson Activity:
297-6201-502 Standard 01.02 September 2000
Cause: output after a conflict in error control
commands. A conflict can occur when both processors
are in the same state (both active or both standby).
Reason Code = 14
Corresponds to ERRMAP entry: ERR CTL CONFL
System Default:
Type:MajorLevel:0
Type:Level:
Default:
Status Panel:MajorAudible:Major
Customer-Selected
Status Panel:Audible:
System selects one processor to be active.
Refer to the System Reboot Procedure in the
Maintenance Procedures Guide section. If the problem
continues, refer to the Error Control II PCA
Replacement Procedure in the Maintenance
Procedures Guide section.