Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 376

4-216 Section 060-INDP-410 Command and Message Guide
Table 7-153
KEY COMMAND NOT AVAILABLE message
2 3 5
KEY COMMAND NOT AVAILABLE
Display: Maintenance terminal
2 3 6
Alarm Level:
N/A
2 3 7
Customer-Selected Alarm Level
2 3 8
Other Alarm Indications
2 3 9
System Recovery Action
2 4 0
Craftsperson Activity:
297-6201-502 Standard 01.02 September 2000
Cause: output when:
a. firmware keyboard command is entered when an
equivalent software command is available. (Software
is running in the BMC system.)
b. message (input) is a keyboard command involving a
disk operation that was given to the standby
processor.
Reason Code = N/A
Corresponds to ERRMAP entry: N/A
System Default:
Type:N/ALevel:N/A
Type:Level:
Default:
Status Panel:Audible:
Customer-Selected
Status Panel:Audible:
Request is aborted.
Refer to the software commands subsection of this
document for the valid commands.