Table 7-100
DISK: DMA INTERRUPT message
1 6 0
Other Alarm Indications
1 6 1
System Recovery Action
1 6 2
Craftsperson Activity:
Table 7-101
DISK: FAILURE GOING ON LINE message
1 6 3
DISK: FAILURE GOING ON LINE
Display: Log message
1 6 4
Alarm Level:
N/A
1 6 5
Customer-Selected Alarm Level
1 6 6
Other Alarm Indications
1 6 7
System Recovery Action
1 6 8
Craftsperson Activity:
BMC II BISYNC Operation, Administration, and Maintenance Guide BMCB001 and up
Section 060-INDP-410 Command and Message Guide 4-173
Default:
Status Panel:MinorAudible:Minor
Customer-Selected
Status Panel:Audible:
Attempt to change disk mode to ONLY mode.
If the attempt is successful, system continues normally.
If the attempt is unsuccessful, refer to the Disk Drive
Diagnostic Procedure in the Maintenance Procedures
Guide section.
Cause: output upon termination due to a failure of
bringing a formerly off-line disk drive unit back on-line.
Reason Code = N/A
Corresponds to ERRMAP entry: DSK ERROR ALM
System Default:
Type:N/ALevel:N/A
Type:Level:
Default:
Status Panel:N/AAudible:N/A
Customer-Selected
Status Panel:Audible:
Disk system is placed in disk ONLY mode.
Refer to the Disk Drive Diagnostic Procedure in the
Maintenance Procedures Guide section.