Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 472

6-34 Section 060-INDP-610 Maintenance Procedures Guide
Procedure 6-10
Boot Recovery
Step Description
99
If program file name and version number from DOS LL command does not match the file
name listed from LSTDIR ALL command, enter the following commands to recreate the
boot file.
>DOS LD (cr)Must be entered for each file listed with DOS LL; there is no
response to this command.
>DOS LL (cr)Should respond BOOT FILE EMPTY, if not repeat DOS LD
until boot file is empty.
>DOS LA (cr)Add program file name and version number to boot file.
Note: Respond to the FILE> prompt with the program file name and respond to the VER> with
the version number.
System responds with the new boot file name and version number.
>DOS LL (cr)Verify correct entry of file name and version number.
100
Power down the standby processor by depressing the rocker switch on the power supply.
101
After 15 seconds, activate the power supply rocker switch by pressing it toward I.
102
User should observe the LED display on the CPU PCA is a lower case 'r.'. When this
display changes to any other character, there should be some steady activity on the disk
drive LED followed by a terminal message STBY BOOT IN PROC.
Note: BMC will automatically attempt to load the program file three times. If the BMC loads
successfully, proceed to step 7. Otherwise, perform the following steps.
297-6201-502 Standard 01.02 September 2000
Sheet 2 of 6