Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 283

Table 4-55
CP DMA Test Failed message
2 0 5
CP DMA Test Failed
Display: Maintenance terminal
2 0 6
Alarm Level:
Processor switch
2 0 7
Customer-Selected Alarm Level
2 0 8
Other Alarm Indications
2 0 9
System Recovery Action
2 1 0
Craftsperson Activity:
Table 4-56
CP I/O FAILURE message
2 1 1 CP I/O FAILURE
Display: Log message
2 1 2
Alarm Level:
Major
BMC II BISYNC Operation, Administration, and Maintenance Guide BMCB001 and up
Section 060-INDP-410 Command and Message Guide 4-123
Cause: 56K Interface DMA test failed.
Reason Code = N/A
Corresponds to ERRMAP entry: CP FAULT
System Default:
Type:MajorLevel:1
Type:Level:
Default:
Status Panel: MajorAudible: Major
Customer-Selected
Status Panel:Audible:
Processor switch
Refer to the 56K Interface PCA Diagnostic Procedure in
the Maintenance Procedures Guide section.
Cause: hardware status from the 56K Interface contains
an illogical value.
Reason Code = N/A
Corresponds to ERRMAP entry: CP FAULT
System Default:
Type:MajorLevel:1
CP NOT AVAIL.
CP NOT AVAIL.