Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 331

Table 7-99
DISK: COMMAND ERROR message
1 (continued)
BMC II BISYNC Operation, Administration, and Maintenance Guide BMCB001 and up
Section 060-INDP-410 Command and Message Guide 4-171
Medium Error,
ID Field CRC Error
Uncorrectable Error
No ID Field Address Mark
No Data Field Address Mark
Block Not Found
Seek Error
Format Failed
No Defect Spare Location Available
Hardware Error,
No Seek Complete
Write Fault
Drive Not Ready
Drive Not Selected
No Track Zero
No ID Field Address Mark
RAM Failure
SCSI Msg Reject Error
SCSI Hardware Error
Select Reselect Failed
Illegal Request,
Primary Defect List Not Found
Invalid Block Address
Invalid Field in CDB
Invalid LUN
Invalid Field in Parameter List
Unit Protection,
Write Protect
Medium Change
Power Up or Reset
Mode Select Change Condition
Data Protect,
Write Protect
Aborted Command,
Parity Error
Initiator Detected Error
Illegal Message
Cause: output when a disk command fails