Table 4-60
CP Modem Loopback Test Failed on SCC Channel x message
2 3 7
Customer-Selected Alarm Level
2 3 8
Other Alarm Indications
2 3 9
System Recovery Action
2 4 0
Craftsperson Activity:
Table 4-61
CP MS CODE xx WAS yy message
2 4 1
CP MS CODE xx WAS yy
Display: Log message
2 4 2
Alarm Level:
N/A
2 4 3
Customer-Selected Alarm Level
2 4 4
Other Alarm Indications
BMC II BISYNC Operation, Administration, and Maintenance Guide BMCB001 and up
Section 060-INDP-410 Command and Message Guide 4-127
Type:Level:
Default:
Status Panel: Audible:
Customer-Selected
Status Panel:Audible:
None
Verify using the CP TEST ACT and CP TEST STDBY
commands. If the test still fails, refer to the 56K
Crossover PCA Replacement Procedure in the
Maintenance Procedures Guide section.
Where: xx = expected code.
yy = received code.
Cause: output when certain message parameter values
are not within an acceptable range for the CP message
task.
Reason Code = N/A
Corresponds to ERRMAP entry: N/A
System Default:
Type:N/ALevel:N/A
Type:Level:
Default:
Status Panel: N/AAudible: N/A
Customer-Selected
Status Panel:Audible: