Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 240

4-80 Section 060-INDP-410 Command and Message Guide
where:
aaaaaa - filename.
vvv - version number (0-255).
To delete a range of versions, enter the following at the maintenance terminal:
>DELETE aaaaaa xxx:yyy (cr)
where:
xxx - starting file version (0-255)
yyy - ending file version (0-255).
DISK
DISK is used to perform various disk operations. The firmware version of
this command is identical to the software version. Refer to the DISK
subsection of the Software Commands subsection for more information.
DMSO ***DMS-10 ONLY***
DMSO is used with the DMS-10 Switching System; the BMC can disengage
the Switching System remote terminal through the SDI port. If disengaged,
the command responses are not routed to the remote terminal. The terminal
may be reactivated by entering a command at the remote terminal and routing
the command to the Switching System port to which the BMC is attached,
SDI port.
Example of command usage
To disengage the DMS-10 remote terminal, enter the following at the
maintenance terminal:
>DMSO x gg (cr)
where:
x - terminal position (1-6)
gg - terminal assignment (00-99).
DMSP ***DMS-10 ONLY***
DMSP is used with the DMS-10 Switching System; it is used to set or
examine the password used by the BMC to log into the DMS-10 maintenance
port at BMC start-up or reboot.
297-6201-502 Standard 01.02 September 2000
Note 22: The above deletes one disk file version.
Note: Output to the remote terminal is preceded by: MSG xx (xx is the
terminal number of the SDI port).