Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 351

Table 7-122
EXCESSIVE INVALID RECORDS message
4 9 (log message)
EXCESSIVE INVALID RECORDS
Display: Log message
5 0
Alarm Level:
Processor switch
5 1
Customer-Selected Alarm Level
5 2
Other Alarm Indications
5 3
System Recovery Action
5 4
Craftsperson Activity:
Table 7-123
FALSE DMA INTERRUPT message
5 5 FALSE DMA INTERRUPT
Display: Log message
5 6
Alarm Level:
N/A
5 7
Customer-Selected Alarm Level
BMC II BISYNC Operation, Administration, and Maintenance Guide BMCB001 and up
Section 060-INDP-410 Command and Message Guide 4-191
Cause: exception report printed whenever the daily
count of invalid call records reaches the threshold value
specified by the VALPARM INVALID site data entry.
Reason Code = 26
Corresponds to ERRMAP entry: EXCESS INV BLKS
System Default:
Type:MinorLevel:0
Type:Level:
Default:
Status Panel:MinorAudible:Minor
Customer-Selected
Status Panel:Audible:
Processor switch
Refer to the Block Display Procedure in the
Maintenance Procedures Guide section.
Cause: output when an erroneous interrupt signal is
received indicating the end of a DMA transfer that has
never occurred.
Reason Code = N/A
Corresponds to ERRMAP entry: DMA COMM FAIL
System Default:
Type:MajorLevel:2
Type:Level: