Nortel DMS-10 Series Installation, Operation And Maintenance Manual page 209

xx - data byte read from specified port.
SYSUTIL IOWRITE
SYSUTIL IOWRITE writes data to a specified I/O port.
Example of command usage
To write data to a specified I/O port, use the following command:
>SYSUTIL IOWRITE port data (cr)
where:
port- specifies the port. Range: 0-FF.
data- data to be written. Range: 0-FF.
The system displays the following message after writing the data to the
specified I/O port:
DATA ENTERED
SYSUTIL MEMWRITE
SYSUTIL MEMWRITE specifies that data is to be written to a specified
address in RAM. The subcommands and related parameters for this command
are listed in the table below.
Table 4-14
SYSUTIL MEMWRITE subcommands
Subcommand
D page addr datalist
P addr datalist
Examples of command usage
To write the specified data at a specified data space address and page, use the
following command:
BMC II BISYNC Operation, Administration, and Maintenance Guide BMCB001 and up
Section 060-INDP-410 Command and Message Guide 4-49
CAUTION
Description
Examines the specified data space information at the specified address.
Examines the specified program space information at the specified
address.
Use of this command may cause a loss
of data.